Your cooling/heating tank is delivered clean from the factory, nevertheless wipe the unit clean prior to initial use. Use a cloth that has been slightly moistened with lukewarm water. Pay attention that no water spills into the air vents of the cooling/heating tank, possible damage may occur to the electronics. Dry off the cooling/heating tank with a cloth after cleaning. Clean the cooling/heating tank periodically or as soon as it becomes dirty.

Attention: Never use solvents or abrasives for cleaning the cooling/heating tank. Never use abrasive brushes and or hard and sharp tools.

Storage of the unit Should the cooling/heating tank not be required for extended periods, disconnect the power cable from the battery, clean the container and leave the lid slightly open. Leaving the lid open will allow air to circulate and help with the prevention of mold buildup. Store the unit in a clean dry climate controlled environment.

Care and Washing Instructions

Odor Mold and Mildew

Jenkins Comfort Systems Vest Treatment and Conditioner ( VTC ) is specially formulated to treat and condition your Eliminator vest. This is a unique formulation of odor neutralizers, preservatives and quaternary compounds that inhibit the growth of mold and mildew on the vest.     Directions: Shake bottle before using. After wearing the Eliminator vest, spray the inside liner with ETC. Allow the vest to air dry prior to use. Before storing the vest, spray both the inside liner and the exterior vest with VTC.

Washing and Cleaning

Shampoo and Conditioner ( SCV ) for the vest is designed to remove body oils and other soils  from the surface of the fabric vest. A special proprietary blend of surfactants and other cleaning agents quickly dissolve and emulsify greases and oils. The shampoo then holds these oils in suspension to allow them to be freely rinsed from the vest. Directions: Mix 6 ounces of SCV with a gallon of warm to hot water in a large bucket or other vessel sufficient to hold the vest and and the cleaning solution. Submerge the vest in the solution and weight it down with a heavy object to keep the vest completely submerged for 10 to 15 minutes. Remove the heavy object and agitate the vest up and down in the cleaning solution several times. If the outside of the vest has heavy deposits of grease or other soils, agitation with a brush may be necessary on those spots. Rinse the vest thoroughly with running water to remove all soap and conditioner. Allow vest to air dry. The garment should be opened completely to facilitate drying.

System Slime Preventer

Jenkins Comfort Systems System Slime Preventer (SSP ) is a proprietary blend of quaternary compounds that are designed to be circulated through the cooling system to help prevent the possibility of algae, slime or other growths occurring in the system. It is specially designed to be compatible with this system. Do not circulate bleach or other anti–slime agents through the Jenkins comfort system cooling unit. Circulation of any substance other than water and SSP through the unit is subject to cancellation of all warranties and guarantees. Directions: Fill the cooling reservoir of the Jenkins Comfort Systems cooling unit to the halfway point. Add four ounces of ( SSP ) per gallon ( 1 ounce per quart ) to the water in the reservoir. Turn the pumping system to the on position after hooking up the bladder connections to the pump and allow the system to circulate for a few minutes. If you are storing the system for more than 120 hours, leave the solution in the system. If you plan on using the system within 120 hours, discharge the solution and rinse thoroughly with clear water.

Pease follow the manufacturers instructions and warnings on the side of the bottle. Proper storage, disposal and handling procedures are outlined.

KEEP THIS AND OTHER CHEMICALS OUT OF THE REACH OF CHILDREN.